Custom® FP1-2 SimplePrep® Pre-Mixed Floor Patch, 1 Gallon

Repairs holes and cracks in concrete and plywood floors prior to installing tile or other flooring. Smooths and fills minor dips and imperfections. Protected by moldgard technology.

• 1 Gallon
• Ready to use
• No mixing
• Fills minor dips and imperfections.

Suitable Substrates:

• For interior use only
• Concrete
• WonderBoard®, cement backerboards
• Ceramic tile
• Exterior Grade Plywood
• Vinyl flooring.

Limitations to the Product:

• Do not use as a wear surface
• Use on non-porous surfaces may lead to an extended drying time.

Technical Data:

• Custom® Building Products is committed to environmental responsibility in both products produced and in manufacturing practices. Use of this product can contribute to LEED® certification.

Instructions:

• Surfaces must be structurally sound, clean, dry and free from grease, oil, dirt, curing compounds, sealers, adhesives or any other contaminant that would prevent a good bond. Glossy or painted surfaces must be sanded, stripped and cleaned of waxes, dirt or any contaminants. Concrete must be cured 28 days and accept water penetration. Concrete must be free of efflorescence and not subject to hydrostatic pressure. Concrete slabs should have a broomed or brushed finish to enhance the bond. Plywood flooring including those under resilient flooring must be structurally sound and meet all ANSI and deflection requirements. For questions about proper subfloor installation, call Technical Services. Smooth concrete surfaces, existing glazed tile, terrazzo, or polished stone should be roughened or scarified. Sheet vinyl must be well-bonded and stripped of old finish. Roughen the surface by sanding or scarifying, rinse and allow to dry. Expansion joints should never be bridged with setting material. Do not sand flooring materials containing asbestos. Ambient temperature, surfaces and materials should be maintained at a temperature above 50° F (10° C) or below 100° F (38° C) for 72 hours.